486 Drag part
-
Sea Hunter
- Posts: 11
- Joined: Thu Dec 22, 2022 10:08 pm
486 Drag part
I am reconditioning a Mitchell 486 (new to me). The drag uses a part; the "Ferodo drag plate", PN 81 482 which appears to be NLA. Is there a substitute for this part?
-
Sea Hunter
- Posts: 11
- Joined: Thu Dec 22, 2022 10:08 pm
Re: 486 Drag part
There does appear that there are a few sources for this part. However, I had seen somewhere that these "Fereodo drag plates" never wear out but can crack. Have not found a carbon fiber or other substitute for this piece.
-
kevin cozens
- Posts: 6
- Joined: Mon Dec 04, 2023 9:54 pm
Re: 486 Drag part
You should be able to buy a loose carbontex drag washer in the correct sizeSea Hunter wrote: ↑Fri Mar 10, 2023 4:36 pm There does appear that there are a few sources for this part. However, I had seen somewhere that these "Fereodo drag plates" never wear out but can crack. Have not found a carbon fiber or other substitute for this piece.